SynchronizationĪrt-Net or sACN outputs can also be synchronized via the use of sync packets in nodes and other output devices that support sync. This priority signal can be used when multiple sACN senders exist on the same network to filter which devices gets output at a given time(assuming the sACN receiver acknowledges priority). The priority range is from 0-200, with 200 being the highest priority. The sACN settings allow you to set whether the sACN is for output, input, or both, set the range of either or both directions, and set the priority. When Broadcast is OFF, only detected devices (from the Devices tab at the bottom) will receive Art-Net. It's generally not a good idea to broadcast all 255 universes of Art-Net unless you truly are using them and have network infrastructure that can handle the traffic load. Using the configuration boxes, the Art-Net Broadcast can be limited to a range of universes for best performance. This can eventually cause performance issues as less-powerful Art-Net devices are forced to read data for all devices all of the time. As a show gets larger, so does the data stream. All Art-Net devices must then parse the incoming data stream looking for data that pertains to them. Use these options to set whether the Art-Net is for output, input, or both, set the range of either or both directions, and to turn on Art-Net Broadcast.Īrt-Net Broadcast mode causes the console to send all Art-Net data to all devices simultaneously. When Art-Net and/or sACN are enabled, additional options appear below for the given type of EtherDMX: Art-Net: Using the EtherDMX generated address is preferred for Art-Net, though you can use a Static or Automatic (DHCP) address. The pop-up allows you to set the label, type of IP address, and for static, allows you to define the exact IP address and Subnet mask you desire. Press IP Settings on any network interface to toggle this popup: In this section, you can see each of your network interfaces, and adjust their settings. Toggle ALL Art-Net and/or sACN output on ALL network interfaces. ![]() EtherDMX Settings:īy default, all EtherDMX is off in the ONYX system. The EtherDMX settings is accessible via the main menu - navigate there by pressing ONYX in the upper-left-hand corner, pressing Menu, and then choose EtherDMX from the menu on the left side.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |